Pros and cons
Folding light source
①New green environmental protection light source: LED uses cold light source, with low glare, no radiation, and no harmful substances are produced during use. The working voltage of LED is low, it adopts DC drive mode, ultra-low power consumption (single tube 0.03~0.06W), electro-optical power conversion is close to 100%, and it can save more than 80% energy than traditional light sources under the same lighting effect. LED has better environmental benefits. There is no ultraviolet and infrared in the spectrum, and the waste is recyclable, has no pollution, does not contain mercury, and can be touched safely. It is a typical green lighting source.
②Long life: LED is a solid cold light source, epoxy resin encapsulation, anti-vibration, there is no loose part in the lamp body, there is no shortcomings such as easy burning of the filament, heat deposition, light decay, etc., and the service life can reach 60,000 to 100,000 Hours, more than 10 times the service life of traditional light sources. The LED performance is stable and can work normally under the environment of -30~+50°C.
③Multi-conversion: LED light source can use the principle of red, green and blue three primary colors. Under the control of computer technology, the three colors can have 256 gray levels and mixed arbitrarily to produce 256X256X256 (that is, 16777216) colors to form different light colors. The combination. The light color of the LED combination changes many ends, which can realize colorful dynamic change effects and various images.
④High and new technology: Compared with the luminous effect of traditional light sources, LED light sources are low-voltage microelectronic products, which successfully integrate computer technology, network communication technology, image processing technology and embedded control technology. The chip size used in the traditional LED lamp is 0.25mmX0.25nm, and the size of the lighting LED is generally above 1.0mmX1.0mm. The working bench structure, inverted pyramid structure and flip chip design of LED die molding can improve its luminous efficiency, thereby emitting more light. Innovations in LED packaging design include high-conductivity metal block substrates, flip-chip designs, and bare-disk casting lead frames. These methods can be used to design high-power, low-thermal resistance devices, and these devices have better illuminance than traditional LEDs. The illuminance of the product is greater.
A typical high luminous flux LED device can produce a luminous flux of a few lumens to tens of lumens. The updated design can integrate more LEDs in one device, or install multiple devices in a single assembly, so that the output lumens is equivalent For small incandescent lamps. For example, a high-power 12-chip monochromatic LED device can output 200lm of light energy, and the power consumed is between 10~15W.
The application of LED light source is very flexible, and it can be made into light, thin and short products in various forms of points, lines and surfaces; LED is extremely controllable, as long as the current is adjusted, it can be dimmed at will; the combination of different light colors can vary widely, and the timing control circuit is used , It can achieve a rich and colorful dynamic change effect. LEDs have been widely used in various lighting equipment, such as battery-powered flashlights, miniature voice-activated lights, safety lighting, outdoor road and indoor staircase lighting, and continuous lighting for buildings and signs.
The emergence of white LEDs is a substantial step for LEDs from marking functions to lighting functions. White LED is the closest to daylight and can better reflect the true color of the illuminated object. So from a technical point of view, white LED is undoubtedly the most advanced technology of LED. White light LEDs have begun to enter some application fields, and products such as emergency lights, flashlights, and flashlights have come out one after another, but they are difficult to popularize because of their high prices. The prerequisite for the popularization of white LEDs is the price drop, and the price drop can only be possible after the white LED has formed a certain market scale. The fusion of the two ultimately depends on technological progress.